Roller burnishing tool for external cones - ARG-K/from 1 mm dia.

Technical Data

Roller burnishing tool for taper bores - IRG-K-1

Machining

Outside taper

Diameter range      

from 1 mm

Rollers

according to requirement

Standard mount

Cylinder shank (with clamping surface on request) or Morse taper 3 - 5

Optional tool equipment

-VDI, HSK etc. mounts

-Inside cooling max. 8 bar coolant pressure

Use parameters to be used

(Please note that this information represents guide values which must be adapted to the individual cases.)

Workpiece oversize

up to 0.01 mm

Tool preclamping

up to 4 mm

Lubrication

Emulsion or oil; filtration of the lubricant (<40µm) can improve the surface quality and the tool life

Pre-machining of workpiece

Surface roughness up to 15 µm

Maximum hardness of workpiece

45HRC

Speed

up to 40 rpm; speeds are calculated from the circumferential speed, based on the largest dia.

Feed rate

0.1 - 0.3 mm/rev; Return traverse always in rapid traverse

Dwell time under pressure

5 - 20 rotations